   This is the procedure to auto log
onto the CIS network using a 1660/Modem
 300 (c) and an auto log file using
'VIDTEX' (c) terminal software.

   Refer to the auto start prg. on your
 'VIDTEX' (c) disk. Load then list the
program and change line 10 to the
filename of the name you give this file.
 An example is on page 38 of the
'VIDTEX' (c) users guide. Then save this
 file under any legal filename.

   Next load 'VIDTEX' (c) and then run
it. Select meta I to create a new auto
log file. Name this file exactly as the
name you gave in line 10 in the above
program. The program will prompt;


with a 1660 modem/300;

        Prompt:$
      Response:_@1_&PHONE NUMBER
        Prompt:$
      Response:_%_%_%^c$
        Prompt:ID:
      Response:YOUR ID NUMBER
        Prompt:word:
      Response:YOUR PASSWARD

At this point I assume that most every
one can enter the proper prompts &
responses to navigate once on line.

        note; $=escape
              _=meta function
              %=wait 2 seconds
              &=wait 1/2 second
              @=dial phone

        When you want to end the auto
log file enter a '$',(escape),at both
Prom	 :,Response: then 'VIDTEX' will
close the file.
        Remove the disk then turn off
the computer and turn it on. Load the
auto start program with the file name
you gave to the first program you saved.
 NOTE;'VIDTEX' and the AUTO START
PROGRAM and the AUTO LOG programs MUST
be on the same disk.
        If you want it to run automatic
then enter the load this way;
        LOAD"your filename",8:
        yes print a ":" after the 8 then
 hold the shift key down and press the
run/stop key. Itshould then print	 OAD
behind the ":".It will load then run by
its self then it will load vidtex,which
will load the auto log file and execute
it.
        Uploaded with 'VIDTEX' (c)
 as a seq file.


any questions leave message in forum


Rick 75606,2167


